Facile synthesis of low band gap ZnO microstructures

Título traducido de la contribución: Síntesis sencilla de microestructuras de ZnO de bajo band gap

V. M. Ovando-Medina, L. Farías-Cepeda, N. V. Pérez-Aguilar, J. Rivera de la Rosa, H. Martínez-Gutiérrez, A. Romero Galarza, E. Cervantes-González, N. Cayetano-Castro

Producción científica: Contribución a una revistaArtículorevisión exhaustiva

9 Citas (Scopus)

Resumen

In this work a simple chemical route was employed to synthesize ZnO microparticles by precipitation from aqueous solution of ZnCl2 as precursor, NaOH as oxidizing and sodium dodecyl sulfate (SDS) as surfactant. Samples of ZnO microparticles were analyzed by scanning electron microscopy (SEM), FTIR spectroscopy, Raman spectroscopy, X-Ray diffraction, UV/Vis-NIR diffuse reflectance, high resolution transmission electron microscopy (HR-TEM), and N2 adsorption-desorption. It was observed from SEM analysis that ZnO microparticles with morphologies resembling six-blade impeller with diameters in the range of 500 nm to 1 m, and sheet-like (approximately 200 nm × 300 nm) were obtained through this technique. X-Ray diffraction and Raman analyses confirmed the obtaining of hexagonal wurtzite ZnO crystal structure. The calculated band gap energy was 3.19eV, which is slightly lower than the average value reported in the literature. Specific BET area of ZnO microparticles was 26.5 m2/g.

Título traducido de la contribuciónSíntesis sencilla de microestructuras de ZnO de bajo band gap
Idioma originalInglés
Páginas (desde-hasta)455-462
Número de páginas8
PublicaciónRevista Mexicana de Ingeniera Quimica
Volumen17
N.º2
DOI
EstadoPublicada - 2018

Huella

Profundice en los temas de investigación de 'Síntesis sencilla de microestructuras de ZnO de bajo band gap'. En conjunto forman una huella única.

Citar esto