Cyclic turbulent instabilities in a thin slab mold. Part I: Physical model

A water-physical model of a funnel-type thin slab mold fed by a two-port submerged entry nozzle (SEN) was employed to characterize the flow of liquid steel using dye tracer, particle image velocimetry, and video recording experiments. The overflow fluid flow pattern was the typical double-roll flow. A cyclic, low-frequency (≈0.01 s^-1), and energetic flow distortion of a short-lived (8 to 12 seconds) inducing high meniscus oscillation was identified. Its intensity grew with high casting speeds (5 and 7 m/min) and with a shallow SEN immersion position (200 mm from the meniscus level to the SEN tip). This distortion originated from the apparent existence of vortex flows located below the two discharging jets, which are formed by shear stresses in their ends that act on the surrounding fluid. These vortexes exert momentum transfer upward through a cascade mechanism from the lowest part of the discharging jets until reaching the region close to the SEN tip. This cascade momentum transfer widens the separation of both jets, enhancing the fluid velocities of the upper rolls, which promotes a high-amplitude standing wave. It is inferred, based on the experimental results, that this flow distortion originated from an instantaneous unbalance of the turbulent kinetic energy in the discharging jets. The negative production of kinetic energy is ascribed as the source of this unbalance, which is compensated by a higher contribution of the turbulent kinetic energy through mean convection and turbulent transport mechanisms manifested through higher velocities. After the restoration of the energy balance, the system yields a stable meniscus to repeat the low-frequency cycle.